Siemens 6ES7141-3BH00-0XA0

As your trusted partner, Hanyite Automation Technology not only provides you with original Siemens 6ES7141-3BH00-0XA0, but also provides one-stop service from selection, quotation, logistics to after-sales, allowing you to save worry and effort and purchase easily.

Siemens SIMATIC S7-300 series digital input module 6ES7141-3BH00-0XA0 is a high-performance module that meets the DIN rail installation standard. Its compact 40mm width design allows it to be easily integrated into the S7-300 series PLC system.

 6ES7141-3BH00-0XA0 uses a front connector (Front Connector) connection method, which is convenient for on-site wiring and later maintenance. The front panel of the module is equipped with an intuitive status indicator (LED), which displays the module's operating status, power status, and the signal status of each channel in real time, providing users with a convenient means of fault diagnosis.

In summary, Siemens 6ES7141-3BH00-0XA0 has high reliability, strong anti-interference ability, and is easy to configure and use. It is an important component of the Siemens S7-300 PLC system.

Parameter:

FAQ：

How to set input delay (Filter) for Siemens 6ES7141-3BH00-0XA0?

Input delay can be set through the programming software of PLC (such as STEP 7). You can set different delay times as needed to filter out short-term interference signals or jitters. The delay time range is usually 0.2 ms to 15 ms.

How to wire?

6ES7141-3BH00-0XA0 uses screw terminals for connection, and you can connect standard wires to the corresponding terminals. For specific wiring methods, please refer to the wiring diagram in the module manual.

What is the protection level?

The protection level of Siemens 6ES7141-3BH00-0XA0 itself is IP20, which means that it can resist a small amount of dust but cannot be immersed in water. Therefore, the module needs to be installed in a control cabinet that meets IP requirements.